Publicité
14 ASSEMBLY
14.1
Checking scope of delivery
Check the machine immediately after delivery for transport damage and missing parts.
14.2
The workplace
Choose a suitable place for the machine. Pay attention to the safety requirements and the
dimensions of the machine. The selected location must ensure a suitable connection to the
electrical supply. Make sure that the machine is placed on a solid and level surface and that the
ground can support the load of the machine. The machine must be levelled at all support points. It
is also necessary to guarantee a distance of at least 0.8 m around the machine. The necessary
distance for the feeding of long workpieces must be provided.
14.3
Assembly
The machine was disassembled for transport and must be assembled as shown below. Before
commissioning, check all screw connections for tightness and tighten them if necessary.
ZIPPER MASCHINEN GmbH
ZI-WP500TN
www.Zipper-Maschinen.at
2. Secure the log carriage with the locking plate by
flipping it downwards (see Fig. B).
3. Stand behind the machine and tilt the wheel axle
to transport it easily (see Fig. C).
Anchoring on level ground
Use four bolts to secure your machine to the
ground. Due to the different ground conditions,
these are not included in the delivery content.
Select the correct bolt type for your soil conditions
(see Fig. D).
1. Assembly wheel axle
Place the wheel axle (1) on the rear side of the base
frame (2) and align the bore holes (see Fig. E, Pic. 1).
Secure the wheel axle (1) to the base frame (2) using
a total of four M8×20 bolts (3), eight washers (4) and
four nuts (5) (see Fig. E, Pic. 2).
ASSEMBLY
25
Publicité
