Publicité
14.4 Electrical connection
Dangerous electrical voltage! The machine may only be connected to the mains supply
and the associated checks carried out by a qualified electrician or under the instruction
and supervision of a qualified electrician!
1.
Check that the neutral connection and protective earthing are functioning properly.
2. Check that the supply voltage and frequency correspond to the specifications of the machine.
Deviation of the supply voltage and frequency
A deviation from the value of the supply voltage of ± 10 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
3. Find the required cross-section of the supply cable (it is recommended to use a cable type
H07RN (WDE0282), taking measures to protect against mechanical damage) in a current
capacity data sheet.
4. Make sure that the power source is protected by a residual current circuit breaker.
5.
Connect the unit only to a properly grounded outlet.
6. When using an extension cable, make sure that it is dimensioned appropriately for the
connected load of the machine (the connected load can be found in the technical data). You
can find the correlation between cable cross-section and cable length in specialist literature or
consult an electrician.
7. Only use extension cords that are also suitable for outdoor use. Using an extension cord suitable
for outdoor use reduces the risk of electric shock.
15 OPERATION
15.1
Work before start-up
• Make sure that the saw blade is firmly secured, in perfect condition, sharpened and
guaranteed to run smoothly.
• Make sure that the rocker unit with the log carriage is fully extended before each use.
Otherwise there is an increased risk of recoil.
• When cutting material, pay attention to foreign objects such as wires, nails, etc. as well as
irregularities in the material, such as knots.
• Check that the moving parts are working properly and are not jammed.
• Ensure that the machine is securely anchored to the ground.
ZIPPER MASCHINEN GmbH
ZI-WP500TN
www.Zipper-Maschinen.at
2. Assembly wheels
Slide two washers (7), a wheel (8) and a third washer
(7) onto the wheel axle (6) one after the other (see
Fig. F, Pic. 1-3).
To secure, insert a cotter pin (9) into the bore hole of
the wheel axle (6) and bend its lower ends apart (see
Fig. F, Pic. 4).
Repeat the same steps for the second wheel.
3. Assembly log carriage extension
Loosen the star screw (10) on the rear side of the log
carriage until the log carriage extension (11) can be
inserted into the guidance (see Fig. G).
Slide the log carriage extension (11) into the
guidance and align it correctly.
Then retighten the star screw (10) to secure it in
place.
WARNING
NOITICE
OPERATION
26
Publicité
