Publicité
• Ensure that the correct power supply and cable are used. Insert the plug into the socket.
15.1.1
Unlocking the machine
15.1.2
Setting the log ruler
15.2
Operating
15.2.1
Start/Stop
Starting the machine: press the green ˝I˝ button on the ON-OFF switch.
Stopping the machine: press the red ˝O˝ button on the ON-OFF switch.
15.2.2
Workflow
1.
Switch on the machine.
2.
Open the top guard.
3.
Position the cut material into the log carriage on the completely extended rocker unit.
4.
Close the top guard again.
5.
Grasp the handle on the left side of the carriage and slide it towards the saw blade cover.
6.
Continue pressing with even force until the cut material has been cut.
7.
After the cut, move the log carriage all the way back again.
8.
If necessary, reposition the cut material and repeat steps 4 to 7 until the work is finished.
9.
Switch off the machine after work.
10.
Wait until the machine stops.
11.
Disconnect the power plug and clean the unit if necessary.
Free blocked log
If the saw blade is blocked, proceed as follows:
1.
Switch off the machine immediately!
2.
Wait until the machine comes to a standstill
3.
Pull out power plug.
4.
Carefully remove the blocked log from the machine.
16 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
16.1
Cleaning
The use of paint thinners, petrol, aggressive chemicals or scouring agents will damage
the plastic surfaces! Therefore, only use mild cleaning agents for cleaning! Make sure
that no water seeps into the machine!
ZIPPER MASCHINEN GmbH
ZI-WP500TN
www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
NOTICE:
the locking plate (1) must be released
before start-up of the machine (see Fig. H)!
1. Loosen the star screw (1) so that the log ruler (2)
can be pulled out (see Fig. I, Pic. 1).
2. Use the scale to set the desired length of the
workpiece (see Fig. I, Pic. 2).
3. Turn the log ruler (2) clockwise to the top (see Fig.
I, Pic. 3).
4. For fixation, retighten the star screw (1) (see Fig. I,
Pic. 4).
NOTICE
27
Publicité
