Publicité
18
TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before starting work to
eliminate defects.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the power supply. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem!
Trouble
Machine does not start
Burn marks on the workpiece
Low power / motor overload
Saw blade get loose after motor is
switched off
Workpiece clamped while advan-
cing
Wrong saw blade direction
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
Possible cause
• Emergency stop switch to
switch off
• switch or a phase is broken
• Overload protection is trigge-
red.
• Safety fuse is blown
•
Open cover plate for saw blades
The blade is blunt
•
Wrong saw blade
•
•
Rip-fence not parallel to saw
blade
•
Dull saw blade
•
Only 2 phases intalled
Fixing nut too lightly fastened
•
• dull blade
• Riving knife thickness does not
match the used blade
Socket wrongly tapped
•
TROUBLESHOOTING
Solution
• Turn the emergency OFF
switch to the right to unlock to
• Repair the defective circuit or
the faulty phase
• Wait until the engine cools
down
• Replace the fuse
•
Cover plate close
Replace the blade
•
Replace the blade
•
•
Adjust rip-fence
•
Replace blade
•
Check power supply
Tighten fixing nut
•
• Replace with sharp blade
Splitting wedge thickness must
•
be greater than or equal to
blade
thickness.
Change polarity of socket
•
(phase-changing)
TKS500S_400V
35
Publicité
