Publicité
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical suit-
ability/training are and remain the most important safety factor in the error-free operation of the
machine. Safe working depends first and foremost on you!
13
TRANSPORT
Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Always check hoists and load slings for adequate load-bearing capacity
and perfect condition, secure loads carefully and never stand under suspended loads.
To ensure proper transport, also observe the instructions and information on the transport
packaging regarding centre of gravity, attachment points, weight, means of transport to be used
and the prescribed transport position, etc.
The machine should be transported to the place of operation by means of a forklift or lift truck.
After the machine has been assembled, it can be transported for short distances with the transport
device or transported by crane or forklift truck using belts of appropriate load capacity and length.
14
ASSEMBLY
14.1
Check delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or
missing parts to your dealer or the shipping company immediately. Visible transport damage must
also be noted immediately on the delivery note in accordance with the provisions of the warranty,
otherwise the goods are deemed to have been properly accepted.
14.2
The workplace
Choose a suitable place for the machine. Pay attention to the safety requirements and the dimen-
sions of the machine. The selected location must ensure a suitable connection to the electrical net-
work as well as the possibility of connection to a dust collection system. Make sure that the ma-
chine is placed on a solid and level surface and that the ground can support the load of the ma-
chine. The machine must be levelled simultaneously at all support points. It is also necessary to se-
cure a distance of at least 0.8 m around the machine. In front of and behind the machine, the nec-
essary distance must be provided for the feeding of long workpieces.
14.3
Assembling the machine
The machine has been disassembled for transport and must be assembled before use. Follow the
instructions below:
Handling the machine with the mains supply intact can result in serious injury or
death. Therefore, do not connect the machine to the power supply before completing
the assembly.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTE
WARNING
WARNING
Assembly base-frame
Raise the lower support leg (1).
•
Mount the short cross support (2), align the
•
mounting hole (3) and tighten the half-round cap
screws (4) with locking knobs (5).
•
Then set the machine up.
TRANSPORT
27
TKS500S_400V
Publicité
