Publicité
interval
Before usage
machine
Before usage
machine
1 x month
Moving parts
1x month
break
17.2.2
Saw blade exchange
Before any manual tool change, stop the spindles, wait for standstill of all tools and
prevent an unintentional restart = unplug the power supply.
During tool change, please use cut protection gloves to avoid risk of injury.
Assembly /Disassembly of saw blade
17.3
Storage
Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
17.4 Disposal
Observe the national waste disposal regulations. Never dispose of the ma-
chine, machine components or equipment in residual waste. If necessary, con-
tact your local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist retailer,
he is obliged in certain countries to dispose of your old machine properly.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
components
Cleaning the machine
Removal of all loose parts / tools
Greasing / lubrication of guides / gear racks /
wheels
Function test to determine that the spindles have
stopped within the specified time (<10 s)
CAUTION
CAUTION
Loosen the two screw M8 (S) on the saw blade
cover (1).
• Swivel off the saw blade cover.
• Loosen the clamping nut (M20, left-hand
thread)
•Remove the saw blade and install a new one.
NOTE:
and not deformed saw blades.
ATTENTION: Check riving knife adjustment
NOTE
activity
Only use well sharpened, crack-free
• Tighten clamping nut, with holding wrench.
34
TKS500S_400V
Publicité
