Publicité
The guards must not be manipulated; in particular, the self-closing mechanism of saw
blade guards must not be blocked (e.g. by using keys).
16.2
Operation
16.2.1
Switch the machine on and off
16.3
Notes on using the table saw
16.3.1
Longitudinal cuts
When performing this operation, the following equipment shall be used for safe working:
Rip-fence
the guard of the saw blade
the riving knife
the insert in the table
push stick when cutting small workpieces (distance between saw blade and fence
<120 mm) and rip-fence with small
When cross-cutting round timber, a template or a holding device is necessary to se-
cure the workpiece against twisting and the use of a suitable saw blade is necessary.
16.3.2
Mitre cuts (cross-cuts) and wedge-cutting
When performing this operation, the following equipment shall be used for safe working:
Mitre gauge (ready for use by lifting onto the saw table)
the guard of the saw blade
the riving knife
the insert in the table
Cross-cuts:
Mitre cuts in the range 0-90° can be carried out by pressing the workpiece to be cut firmly against
the stop surface of the mitre gauge.
Wedge cuts:
To do this, set the rotary part to 0° and secure it with the adjusting handle. Place the workpiece in
the recess and saw through with even pressure.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
Starting saw blade movement by pressing button (1).
Normal stop:
Press the OFF-button (2). Both blades stop movement.
NOTE
OPERATION
32
TKS500S_400V
Publicité
