Publicité
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Assembly rip-fence
Fasten the clamping device (1) for the rip-fence
•
(stop) to the table top with two cheese head
screws M6, two washers and two nuts.
•
Attach the fixing plate (2) to the stop fixing (3) us-
ing two M6 screws, two washers and two nuts.
NOTE
do not tighten yet.
Insert stop
•
High contact surface in position (A)
Low contact surface in position (B)
and then clamp it.
•
Insert rip fence in clamping device
Operation instruction:
Locking/clamp = lift flap
release = press down the flap
Assembly mitre gauge:
•
Insert a round-head screw M8 x 70 from below
into the mitre gauge, fix with 8 mm washer and
handle.
Carry out adjustment:
Adjust the 90° angle between the stop (3) and the
saw blade using the hexagon head screw (2). (Use a
right angle gauge...not included in the scope of deliv-
ery and then make a test cut for verification).
Assembly transport wheels
Assemble the wheel group (1) to the lower sup-
•
port leg using bolts and nuts.
Assembly hook for push-stick -tools:
Attach the hook to the frame using the nut
ASSEMBLY
30
TKS500S_400V
Publicité
