Publicité
Feed only with the hand on the mitre gauge (hands away from the wood)
Only remove workpieces (wedges) after the machine has come to a standstill. To
do this, switch off the machine and wait for the saw blade to come to a standstill.
17
CLEANING, MAINTENANCE, STORGE, DISPOSAL
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
17.1
Cleaning
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is also a prerequisite for the safe operation of the machine and its long service
life. Therefore, clean the device after each use and remove dust and dirt. Use personal protective
equipment (gloves and eye protection when using compressed air). Ensure that the saw blade pro-
tection is free from wood residues and sawdust. Cleaning is best done with compressed air or a
hand brush. Also make sure that you keep the table surface free of resin.
17.2
Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Before each operation, check that the safety devices are in perfect condition.
•
•
Check the connections for tightness at least once a week.
•
Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
17.2.1
Maintenance schedule
The type and degree of machine wear depend on the operating conditions. The following intervals
apply when the machine is used within the specified limits:
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
CAUTION
WARNING
W A R N I N G
NOTE
33
TKS500S_400V
Publicité
