Publicité
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Assembly saw blade:
Loose two screws M8 (S) on the saw blade cover (1).
• Swivel off the saw blade cover.
• Loosen the clamping nut (M20, left-hand thread).
CAUTION
When handling circular saw blades when
changing tools, please use safety gloves to
avoid risk of injury.
• Install the saw blade.
NOTE:
Use only well sharpened, crack-free and not de-
formed saw blades.
• Tighten clamping nut, with holding wrench (LEFT-
HAND THREAD!)
• Fold up the saw blade cover and tighten both screws
M8 again.
Assembly riving knife with saw blade protection cover.
•
Place the already mounted saw blade protection
cover with riving knife from above between guide
plate and clamping plate.
Set the distance between riving knife and saw
•
blade to 3 - 8 mm (a) and tighten the clamping
plate with four hexagon head screws and wash-
ers (2).
NOTE:
The cover is mounted ready for operation and
•
must not be removed for operation.
•
Make sure that the cover always rests on the ta-
ble top with its own weight, but that the two
screws are tightened backlash-free.
-Adjustment of riving knife ( alignment):
The riving knife must be aligned with the saw blade, oth-
erwise it must be corrected. Loosen the 2 hexagon head
screws (S1) on both sides.
Align the riving knife.
Slightly tighten the hexagon head screws (S1).
Align the riving knife to the saw blade and retighten the
four hexagon head screws (S1).
Check the gap setting for the saw blade.
ASSEMBLY
28
TKS500S_400V
Publicité
