Publicité
Table of contents
1
Introduction ........................................................
2
Product description (Fig. 1) ................................
3
Scope of delivery (Fig. 2) ...................................
4
Proper use..........................................................
5
General safety instructions for compressed air
equipment ..........................................................
6
Technical data....................................................
7
Unpacking ..........................................................
8
Assembly............................................................
9
Before commissioning........................................
10 Operation ...........................................................
11 Working instructions...........................................
12 Maintenance and cleaning .................................
13 Storage...............................................................
14 Transport............................................................
15 Repair & ordering spare parts ............................
16 Disposal and recycling .......................................
17 Troubleshooting .................................................
18 EU Declaration of Conformity.............................
Explanation of the symbols on the
product
Symbols are used in this manual to draw your attention to
potential hazards. The safety symbols and the accompa-
nying explanations must be fully understood. The warn-
ings themselves will not rectify a hazard and cannot re-
place proper accident prevention measures.
Attention! Failure to observe the safety signs
and warning information affixed to the prod-
uct and failure to observe the safety and op-
erating manual can result in serious injury or
even death.
Before commissioning, read and observe
the operating manual and safety instruc-
tions!
Wear safety goggles.
Wear hearing protection.
If dust builds up, wear respiratory protection!
Running direction of the sanding disc
The product complies with the applicable
European directives.
14 | GB
1
Introduction
14
Manufacturer:
14
Scheppach GmbH
14
Günzburger Straße 69
15
D-89335 Ichenhausen
Dear Customer
15
We hope your new product brings you much enjoyment
17
and success.
17
Note:
18
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
18
damage to the product or caused by the product arising
18
from:
19
• Improper handling
19
• Non-compliance with the operating manual
20
• Repairs carried out by third parties, unauthorised spe-
cialists
20
• Installing and replacing non-original spare parts
20
• Improper use
20
Note:
21
The operating manual is part of this product.
21
It includes important instructions for the safe, proper and
economic operation of the product, for avoiding danger,
for minimising repair costs and downtimes and for in-
creasing the reliability and extending the service life of the
product. In addition to the safety instructions in this oper-
ating manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety instruc-
tions before using the product. Only operate the product
as described and for the specified areas of application.
Keep the operating manual in a good place and hand
over all documents when passing the product on to third
parties.
2
Product description (Fig. 1)
1.
Housing
2.
Trigger lock
3.
Trigger lever
4.
Handle
5.
Plug nipple
6.
Speed control
7.
Spindle lock
8.
Eccentric spindle (with sanding plate holder)
9.
Sanding wheel
10.
Protective collar
11.
Sanding sheet
12.
Oil container
3
Scope of delivery (Fig. 2)
Item Quantity Designation
5.
1 x
9.
1 x
10.
1 x
11.
5 x
12.
1 x
1 x
1 x
www.scheppach.com
Plug nipple
Sanding wheel
Protective collar
Sanding sheet
Oil container
Compressed air eccentric sander
Operating manual
Publicité
