Publicité
You can find out how to dispose of the disused
device from your local authority or city
administration.
Fuels and oils
• Before disposing of the product, the fuel tank and the
engine oil tank must be emptied!
17 Troubleshooting
Fault
Engine does not start
Product becomes slower during
work
Wood gets burnt during sanding. Sanding disc is covered with
18 EU Declaration of Conformity
Translation of the original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the product
described here complies with the applicable directives
and standards.
Brand:
SCHEPPACH
Art. designation:
COMPRESSED AIR ECCENTRIC
SANDER
Item No.
7906100719
EU directives:
2014/35/EU, 2014/30/EU, 2006/42/EU, 2011/65/EU*
* The object of the declaration described above fulfils the
regulations of the directive 2011/65/EU of the European
Parliament and Council from 8th June 2011, on the re-
striction of the use of certain hazardous substances in
electrical and electronic equipment.
Applied standards:
EN ISO 11148-8:2011
Possible cause
Damaged operating lever
Product is not connected to
compressed air
Too much pressure is applied
to the workpiece.
Pressure drop / insufficient
pressure (bar)
grease.
Excessive pressure was ap-
plied to the workpiece.
www.scheppach.com
• Fuel and engine oil do not belong in household waste
or drains, but must be collected or disposed of sepa-
rately!
• Empty oil and fuel tanks must be disposed of in an en-
vironmentally friendly manner.
Remedy
Replace all damaged parts before you use your sander
again. Contact your local service centre or an autho-
rised service station. Every attempt to carry out a re-
pair, can be dangerous if it is not done by skilled per-
sonnel.
Connect to compressed air
Apply less pressure to the workpiece.
Increase pressure (bar) (max. 6.3 bar)
Replace the sanding sheet.
Reduce the pressure applied to the workpiece.
Documentation authorised representative:
Ann-Katrin Bloching
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 07.03.2024
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management
GB | 21
Publicité
