Publicité
3-in-1 Cordless Handheld Vacuum
Blowing Nozzles
Attaching:
•
Slide one of the nozzles (11, 14, 15)
as far as it will go into the air outlet (6)
(Picture D).
•
For the large blower nozzle, also align
the catches on the air outlet and the
recesses on the blower nozzle. Then turn
the blower nozzle clockwise as far as it
will go.
Detaching:
•
Pull the nozzle (11 or 14) off the device.
•
Turn the large blower nozzle anti-clock-
wise and pull it off the device.
Vacuum nozzles
Attaching:
1. Remove the collecting container (2) from
the motor unit (5) (see the "Collecting
Container" section).
2. Slide one of the nozzles (11 or 14)
into the air inlet (4) as far as it will go
(Picture E). Align the recesses on the
nozzle and the bars on the air inlet with
each other.
Detaching: Pull the nozzle off the device.
Brush Attachments
Attaching:
•
Slide the flat brush attachment (12) onto
the flat end of the crevice nozzle (16).
•
Slide the round brush attachment (13)
onto the narrow end of the large blower
nozzle (15).
Detaching: Pull the brush attachment off
the nozzle.
CHARGING UP THE
BATTERY
Please Note!
■
Make sure that the charger cable does
not present a trip hazard.
■
Do not charge on a computer because
the high charging current could damage
the computer.
■
It is essential that you charge up
the battery fully before you first use
the device in order to achieve the
maximum charging capacity. If the
battery is fully discharged during use,
it must be fully charged up again before
it is next used.
If the device cannot be switched on,
the battery is too weak and needs to be
charged:
1. First plug the charger cable into the
charging socket (9) and then connect it
to a power source with a USB interface
(preferably via a USB mains adapter to
the plug socket).
The charging process begins and the
control lamp (8) lights up red.
As soon as the control lamp lights up
green, the battery is fully charged.
2. Disconnect the charger cable from the
power source and then from the charging
socket.
EN
13
Publicité
