Publicité
ESTABLISH AN AVERAGE PIECE WEIGHT (APW)
Each time a new type of part is counted, the nominal
weight of one piece (average piece weight or APW)
must be established using a small quantity of pieces.
This APW is stored until replaced by another APW.
Two methods establish the APW value:
• The actual APW is known.
• The APW must be derived by weight. For this case
the current sample size will be used.
To choose a different value, establish it beforehand,
using the SAMPLE SIZE button. (See Set a Known
Average Piece Weight.)
SET A KNOWN AVERAGE PIECE WEIGHT (APW)
1. To adjust the APW value directly, touch the APW
button. A numeric input window appears.
2. Key in the desired APW, then press √. The display
returns to the previous screen with the new APW
value highlighted.
3. To return to the counting home screen, touch
RETURN TO APPLICATION.
SET A NEW AVERAGE PIECE WEIGHT (APW) – DERIVED
1.
To establish a new APW, touch the RECALCULATE APW
button. The APW Screen is displayed.
NOTE: The sample size that is displayed will be used.
To use a different sample size, change that first.
PAGE 8 OF 106
OPERATION CONTINUED
2. Follow the screen instructions to establish a new APW.
3. Press ACCEPT to capture the value and return to the
4. To return to the counting home screen, touch
SAMPLE SIZE
The sample size can be 1 to 10,000 pieces. The default
sample size is 10. Once a sample size is changed, the
balance will immediately open the recalculate APW
screen, expecting to establish a new APW.
The current sample size is shown on the settings screen.
1. To adjust the sample size, touch the SAMPLES button.
Actions available: TARE, CANCEL OR ACCEPT.
settings screen. The settings screen returns with the
new APW value highlighted.
RETURN TO APPLICATION. The home screen shows
10 pieces at the new APW.
A numeric input window appears.
0924 IH-4737
Publicité
