Publicité
ENGLISH
Protecting your dishwasher for long periods
Your dishwasher should be protected from freezing
if you plan to leave it for extended periods in an
unheated place. Have a qualified person do the
following:
To disconnect service:
1. Turn off the electrical power to the dishwasher
at the supply source by moving fuses or tripping
circuit breaker.
2. Turn off the water supply.
3. Place a pan under the inlet valve, then disconnect
water line from the inlet valve and drain it into a
pan.
Troubleshooting
If the appliance does not start or it stops during
operation, first check if you can solve the problem by
yourself with the help of the information in the table
or contact an Authorised Service Centre.
WARNING!
may result in serious risk to the safety of
the user. Any repairs must be performed by
qualified personnel.
Problem
The dishwasher won't
start
The dishwasher beeps
at the end of the cycle
The rinse aid light is
on
The dishwasher runs
too long
Repairs not properly done
Possible cause
The door may not be closed
properly.
The power is off or not
connected.
The delay start option is
selected.
The child lock is activated.
(selected models)
The wash cycle has been
completed.
The rinse aid level is low.
(LED screen shows "
The dishwasher is
connected to a cold water
supply.
The cycle time varies,
depending on the soil level
of the dishes.
The sanitize option is
selected.
4. Disconnect drain line and drain the water into a
pan.
To restore service:
1. Reconnect the water, drain, and electrical power.
2. Turn on water and electrical power supply.
3. Fill the detergent cup and the rinse aid cup and
run the dishwasher through a heated-wash cycle.
4. Check all connections to make sure they do not
leak.
CAUTION!
•
If an overflow occurs, turn off the main water
supply before calling for service.
•
If there is water in the base pan because of an
overfill or small leak, the water should be removed
before restarting the dishwasher.
Make sure that the door is closed and latched.
Make sure that the power is connected and turned on.
Refer to the "Starting a Program with delay start"
section.
Deactivate the child lock.
This is normal.
Add rinse aid.
")
Make sure that the dishwasher is connected to a hot
water supply. If not, change the water supply to a hot
water source.
When heavy soil is detected, the auto, normal, heavy
cycles will automatically increase the cycle time.
If the sanitize option is selected, the cycle time
will be increased to meet the sanitize temperature
requirement.
Possible solution
18
Publicité
