Publicité
ENGLISH
Problem
The dishes are not
clean enough
The dishes are not
drying enough
Spots and filming on
dishes
Etching
Detergent left in
dispenser cup
The detergent
dispenser will not
close
Water remains in the
dishwasher.
The dishwasher does
not drain properly.
Suds in the tub
Possible cause
The water pressure is too
low.
The inlet water temperature
is too low.
Dishes are too close
together.
Improper use of detergent.
The selected cycle is not
suitable for the soil level on
the dishes.
The spray arms are blocked. Make sure that the spray arms are not blocked and
The rinse aid dispenser is
empty.
Dishes are loaded
improperly.
The cycle you chose did not
include drying.
Water hardness is too high.
Dishes are loaded
improperly.
Old rinse aid is used.
The rinse aid dispenser is
empty.
Using too much detergent.
The inlet water temperature
exceeds 158°F (70°C).
Detergent may be too old.
The spray arm is blocked.
Improper operation of the
detergent cover.
The previous cycle has
not finished or has been
interrupted.
The drain is clogged.
The drain hose is kinked.
Using improper detergent.
Possible solution
Use your dishwasher when the water pressure is
normal.
Make sure that the dishwasher is connected to a hot
water supply. If not, change the water supply to a hot
water source. Use your dishwasher when hot water
demand is low.
Reload the dishwasher as shown in "Operating
instructions".
Add detergent depending on the water hardness and
washing cycle you choose. Use fresh detergent.
Choose a different cycle with a longer washing time.
can rotate freely. Refer to the Cleaning section.
Fill the rinse aid dispenser.
Reload the dishwasher as shown in "Operating
instructions".
Choose a cycle with drying.
For extremely hard water, install a water softener.
Reload the dishwasher as shown in "Operating
instructions".
Use fresh, liquid rinse aid.
Fill the rinse aid dispenser.
Use less detergent if you have soft water.
Lower the inlet water temperature.
Use fresh detergent.
When you load the dishes, make sure that the spray
arms are not blocked.
Add detergent and rinse aid according to the
instructions in this manual. See "Filling the detergent
dispenser" and " Filling the rinse aid dispenser".
Make sure that the current cycle is finished.
Check the air gap if you have one. Make sure the
disposer is empty if connected to the dishwasher.
Make sure that the drain hose is not kinked and is
properly connected.
Make sure to use only automatic dishwasher
detergent.
19
Publicité
