Publicité
ENGLISH
Wash cycle selections
Cycle times are approximate and will vary with
options selected. Hot water is necessary to activate
dishwasher detergent and melt fatty food soils.
An automatic sensor checks the incoming water
temperature and, if it is not hot enough, the timer
will delay the cycle to allow automatic water heating
during the main wash. If the Extra Dry or Sanitize
option is selected, an even higher temperature will be
assured to handle heavier soil loads.
Starting a program
CAUTION!
Do not remove the baskets
from the dishwasher before starting a wash
cycle.
1. Keep the appliance door ajar.
2. To select a desired program, press the Program
button repeatedly.
The program indicator turns on and the display
shows the program duration.
3. Press the Function button to select desired
function. The function indicator turns on.
4. Press START/Reset.
5. Close the appliance door to start the program.
Starting a program with delay start
1. Select a program.
2. Press
repeatedly until the display shows the
delay time you want to set (from 1 to 24 hours).
3. Press START/Reset once, then close the door within
4 seconds. The timer begins to count down.
4. If you open the appliance door while the delay
timer is running, the timer will pause. Be sure to
press START/Reset before closing the door again,
then the timer will resume counting down.
5. When the countdown is completed, the program
starts.
Note: To cancel the delay setting and begin the cycle
before the delay period is complete, press and hold
START/Reset for 3 seconds.
Adding a dish after the appliance is started
To add or remove items after the wash cycle starts:
1. Open the door slightly and wait a few seconds until
wash action stops before completely opening.
2. Add the item.
3. Press START/Reset and firmly close the door within
4 seconds. The cycle automatically resumes.
WARNING!
the door slowly and wait for the spray arms and
wash action to stop completely. Hot water may
splash out of dishwasher. Failure to do so may
result in injury.
Cancelling the program
To cancel a running cycle, slightly open the door, then
press and hold START/Reset for 3 seconds. The screen
will flash "60". Press and hold START/Reset again for
3 seconds, then the dishwasher will return to standby
mode. lf the door is closed during the screen flashing
period, the dishwasher will drain and return to
standby mode after 60 seconds.
At the end of the program
1. The appliance will stop automatically once the
Program has completed.
2. Turn off the faucet.
When the program is completed the display shows
0:00.
Unloading the baskets
For better drying results keep the appliance
door ajar for some minutes before you remove
the dishes.
1. Let the dishes cool down before you remove them
from the appliance. Hot dishes are easily damaged.
2. First remove items from the lower basket then the
upper basket.
At the end of the program water can still remain
on the sides and on the door of the appliance.
Activating/deactivating the keypad tone
1. Press the Power button to switch the appliance on.
2. Press and hold
seconds to activate or deactivate the keypad tone.
3. The keypad tone is silenced by default, and is
silenced again if the power is turned off after the
keypad tone has been activated.
Floor indicator lamp (signal light)
1. The signal light will show the time remaining in the
wash cycle or the delay status when the door is
closed.
2. When the dishwasher finishes a cycle, the signal
light will show "000" for 15 minutes.
3. If any error codes are displayed, please see
Troubleshooting.
TO AVOID BURN INJURY: Open
and
simultaneously for 3
14
Publicité
