Publicité
ENGLISH
Symbol
Name
Sanitized
Clean
Display
Shows the remaining hours and minutes of the
current cycle, delay hours remaining, and error codes
(see "Troubleshooting" > "Error codes" section).
Delay range : 1,2,3...8,12,16,20,24H
If the Delay Start option is selected, the display shows
the number of delayed start hours.
Operating instructions
Before first use
1. Fill the rinse aid dispenser.
2. Insert the mains plug into the socket. The power
supply is 120V/60 Hz.
3. Turn on the faucet. Make sure that the water
supply is turned on to full pressure.
4. Start a Program to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
Refer to "Using your dishwasher".
5. Close the dishwasher door firmly.
Filling the rinse aid dispenser
Your dishwasher is designed to use a liquid rinse aid
which is automatically released during the hot rinse
phase. The rinse aid helps to dry the dishes without
streaks and stains. For best drying performance,
always use rinse aid.
Do not use a solid or bar-type rinse aid. Under normal
conditions, the rinse aid will last approximately one
month. Try to keep the dispenser full, but do not over
fill it.
Note: The Extra Dry option will not work without rinse
aid.
CAUTION!
Do not add regular detergent to
the rinse aid reservoir.
Turns on after the cycle is finished with the sanitize function.
Turns off in 1 minute after the door is opened, any button is pressed or
the door is closed again.
Turns on after a full cycle is finished and the door is opened.
Turns off in 1 minute after the door is opened, any button is pressed or
the door is closed again.
1. Find the rinse aid
dispenser on the inside
of the door.
Description
After the machine starts operation, the display shows
the remaining time of the selected cycle.
Note: If the remaining time on the display suddenly
increases or decreases by several minutes, this means
that the Smart Sensor is checking the turbidity of the
water and adjusting the required amount of water
refill based on the level of the soil.
CAUTION!
the full level indicator. Excess rinse aid can
overflow during the wash cycle.
The rinse aid empty notification
Always add the rinse aid if the LED screen shows "
2. Open the rinse aid
reservoir cap as shown in
the figure.
3. Fill the rinse aid reservoir
with rinse aid to the
indicated level.
Tip: Use the viewing port
when filling the rinse aid
reservoir.
Do not fill the reservoir above
4. Close the rinse aid
reservoir cap firmly by
pressing down.
Note: Wipe up any spills
with a damp cloth.
10
".
Publicité
