Publicité
The cutterhead does not move
while the motor is running.
The workpiece is not feed into
the machine by the rollers.
The thicknesser table cannot be
adjusted in height.
The surface of the workpiece is
not flat and smooth in
thicknessing mode.
The surface of the workpiece is
not flat and smooth in planning
mode.
11. Reparation
Repair, modification and inspection must be carried out by a LEMAN Authorized Service Center.
In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country
must be observed.
12. Accessories
You will find the list of accessories available from your retailer shop or by referring to our website:
www.leman-sa.com
Set of 2 blades 210 x 22 x 1.8 mm 1 cut
The security switch is deactivated.
The drive belt has snapped or is
broken.
The chain has skipped or is broken.
The table is dirty.
The rollers are dirty or clogged.
The wood id too wet.
Elevating screws are dirty or seized.
The blades are poorly sharpened.
The table is bent or badly adjusted.
The blades are poorly sharpened.
The blades are not adjusted
properly.
The output table is not adjusted
properly.
The fence is not set properly.
38
- Fit the dust collector correctly
and lock it with the security keys.
- Check the belt and change it if
necessary.
- Check the chain and change it
if necessary.
- Clean the table and lubricate it.
- Clean the rollers.
- Use dry wood but not green
wood.
- Clean the elevating screws and
oil them.
- Change the blades.
- Contact your authorized
service center.
- Change the blades.
- Adjust the blades on the
cutterhead.
- Adjust the output table.
- Adjust the fence setting.
Reference: 210701 (the set)
Publicité
