Alarm Configuration Page - Bodet Profit 750 Manuel D'installation Et De Mise En Service

o Multicast: In this case, the NTP server broadcasts the time on the Multicast address given to
it. The Multicast address of the clients (receivers) must be the same as that on which the server
broadcasts.
By default, Bodet products transmit or receive using the Multicast address: 239.192.54.1
239.192.54.1 The Multicast addresses are included between 224.0.0.0 and 239.255.255.255.
o By DHCP: As for Unicast mode, except the NTP server addresses are automatically retrieved
via the DHCP server (option 42 enabled on the DHCP server)
The Save buttons are used to save any settings entered on this page.

5.4 Alarm configuration page

Clock supervision can be used to ensure the clock is operating correctly.
It monitors a certain number of settings.
CAUTION: The number of settings monitored may vary according to your model of
clock. As a result, some settings may be inaccessible (shaded cells).
There are two types of supervision: "basic" supervision, which gives you access to a limited
number of control settings and "advanced" supervision, which provides a greater level of
monitoring of the clock.
Basic supervision
This page is used to enable clock supervision, to define the information to be transmitted and the
destination server. One or more settings can be defined and configured as alarms. The information
displayed is described below:
Advanced supervision
EN
45