Publicité
Once the wire is 1 – 2 cm out of the torch (M),
release the switch.
Subsequently turn off the welder.
M
Replace the contact tip (12).
Ensure the contact tip is compatible with
the diameter welding wire you are using.
12
Reattach the torch nozzle (7) to the torch (M)
by turning it clockwise.
M
7
MAINS CONNECTION
The arc welder is designed for use with single phase alternating current 230 V AC / 50 Hz and
is double-insulated. Make certain that the rated voltage stated on the tool's rating plate
matches the local mains voltage.
If the work area is not close to the mains outlet, use an extension cable with sufficient
conductor diameter (min. 1.5 mm
2
).
The extension cable used should be as short as possible.
Mains circuit: The mains circuit must be equipped with a trip switch or fuse with a maximum
rating of 16 A (slow blow).
The machine may only be connected to a properly earthed mains socket. Repairs may only
be carried out by a qualified electrician.
95
Publicité
