Publicité
Specifications
MIDI Data Format
Reception Format
1. Note On
5. Active Sensing
This message is received on the MIDI channel specified
in the currently selected BANK when CONTROLLER
1
or CONTROLLER 2 is: assigned to «KEY
NOTE
or
«KEY VEL. When a NOTE ON message is received, the
value of the assigned effect parameter is changed accord-
ing to received the velocity value.
And, for programs of PI1 or PI2, this is received as mes-
sage to control pitch shift value. The velocity value is
ignored. Reception is not possible when the base KEY
parameter is OFF.
status
1001 nnnn nnnn = channel number *1
Ist data
Okkk КККК kkkkkkk = note number *2
2nd data Ovvv vvvv vvvvvvv z velocity *3
2. Control Change
This message is received on the MIDI channel specified
in the currently selected BANK when CONTROLLER
1
or CONTROLLER 2 is assigned to control number.
When a CONTROL CHANGE message is received, the
value of the assigned effect parameter is changed accord-
ing to the received control value.
status
1011 nnnn
nnnn = channel number *1
15: data
Оссс
сссс
ссссссс = control number *4
2nd data Оууу уууу
ууууууу = control value *4
3. Program Change
This message is received on the MIDI channel specified
in the currently selected BANK. When
a PROGRAM
CHANGE
message
is received,
the effect program
assigned to the received program number in the program
change assignment table of current BANK is selected.
status
1100 nnnn nnnn = channel number *1
Jet data
Oppp pppp ppppppp = program number *6
. Channel Pressure
This message is received on the MIDI channel specified |
in the currently selected BANK when CONTROLLER
1
or CONTROLLER 2 is assigned to CHANNEL PRESS.
When a CHANNEL
PRESSURE
message is received,
the value of the assigned effect parameter is changed
according to the received pressure value.
status
1101 nnnn nnnn = channel number *1
151 data
Оууу vvvv vvvvvvv = pressure value *7
40
After ACTIVE SENSING has been received, if the inter-
val time is more than 300 milli seconds, the MIDI volume
is set to maximum.
1111 1110 active sensing
. Timing Clock
|
For programs of TDL or TMD, when the ТҮР parameter
is MIDI, the delay time is set to interval time of TIMING
CLOCK.
1111 1000 timing clock
. Notes
*1 channel number
noon | channel number
0
1
15
16
*2 note number
kkkkkkk = 0 — 127
*3 velocity
ууууууу = 1 — 127
*4 control number
ссссссс = 1 — 31, 64 — 95
*5 control value
УҮҮҮҮҮҮ = 0 ~ 127
*6 program number
PPP рррр
0
1
127
128
*7 pressure value
vvvvvvv = 0 ~ 127
Publicité
