Publicité
Chapter 5: Remote Control
- Speed Switching -
@ Set Up Procedure
1. Press the [ W ] or [ À ] button to select the effect program to be controlled.
2. Press the [UTILITY] button to show the FSW FUNCTION display.
3. Press the[
W]or[ A ] button to select "EFFECT TRIGGER".
4. Press the [EDIT] button to show the TRIGGER ASSIGN display.
5. Press the [ W ] or[ A ] button to select "МОР".
6
. Store the setting.
€ Operation Procedure
1. Connect the foot switch to the MEMORY INC/DEC TRIGGER jack on the rear panel.
2. Press the foot switch to change the SPD parameter as and when required. The parameter for
will be switched as follows.
OFF — SLOW — FAST > SLOW > OFF — SLOW — FAST
.....
- Ducking -
© Set Up Procedure
= 1. Press the ГУ ] ог [ А | button to select the program to be controlled.
. Press the [UTILITY] button to show the FSW FUNCTION display.
. Press the [ V | or [ A | button to select "EFFECT TRIGGER".
. Press the [EDIT] button to show the TRIGGER ASSIGN display.
. Press (ће [ W ] or[ À ] button to select the effect section to be controlled.
~ Ui
RR C
N
. Store the setting and switch to Play mode, then the effect will be bypassed.
_ € Operation Procedure
|
1. Connect the foot switch to the MEMORY INC/DEC TRIGGER jack on the rear panel.
2. Press the foot switch to apply the selected effect. When the pedal is not pressed, the effect
will be ducked (bypassed). Delay echoes will continue even after the pedal has been released.
30
Publicité
