Publicité
Chapter 4: Effect parameters
Delay + Reverb — D + R
This effect uses delay and reverb effects in parallel. The same signal is fed to each effect, then
the output of each effect is mixed.
Left Channel
DLYL
Delay Time
0.1 - 750 msec
|
Right Channel
DLYR
Delay Time
0.1 ~ 750 msec
Feedback Level
0 - 100%
L/R Balance
PDLY | Pre-delay
0.1 ~ 190:0 msec
RVT
High Frequency
1-10
Ratio
|
The amount of effected signal that is fed
back into the effect.
If the DLYL and DLYR parameters are set to
the same (or similar) delay times, this effect
may sound like a signal phasing problem. If
so, adjust the L/R parameter to correct it.
L50 ~ L-H ~ R50
Reverb length.
Delay/Reverb
Е
0 = dry signal.
Mixing Balance
0 - 100%
50 = 50% delay + reverb 50% dry signal.
100 = 100% delay + reverb.
Output Level
— co, -30 dB ~ +6 dB
Sets the output level of the effect.
Filter Type
HPF, LPF
HPF:THRU,
32 Hz - 1.0 kHz
LPF: 1.0 kHz - 16 kHz,
THRU
O
OUTPUTL
Cut Off Frequency
O
OUTPUTR
D + R Block Diagram
25
Publicité
