Hitachi ADVANCED COLOR PC-ARFH2E Manuel D'installation Et D'utilisation page 82

1.18.3 Cascade configuration
This menu is only available for YUTAKI Cascade Controller
Supply setting offset
• To set YUTAKI Sub Units to work at a setting temperature higher than setting
temperature determined by YUTAKI Cascade Controller
• 3°C by default (from 0 to 15°C)
Modules configuration:
Configure the status, refrigerant cycle address, indoor unit address and individual DHW for
each module. (See Modules Configuration for more information)
PMEN0597 rev.1 - 06/2023
1
73