Hitachi ADVANCED COLOR PC-ARFH2E Manuel D'installation Et D'utilisation page 113

◆ List of available sensors:
• Deactivated
• Two3: (Fixed in sensor 1 if boiler is installed): Use this sensor to monitor water temperature
when boiler is used.
• Swimming Pool: (Fixed in sensor 2 if swimming pool is installed): Use this sensor when
swimming pool is used in order to monitor swimming pool temperature.
• Solar panel sensor: Use this sensor when Total control is configured to monitor Solar Panel
temperature.
• C1 + C2 Ambient: Use this sensor when auxiliary ambient temperature sensor is used for C1 and
C2.
• C1 Ambient: Use this sensor when auxiliary ambient temperature sensor is used for C1.
• C2 Ambient: Use this sensor when auxiliary ambient temperature sensor is used for C2.
• Outdoor sensor (NTC): (By default sensor 3) To connect to the controller an auxiliary outside
temperature sensor in case the heat pump is located in a position not suitable for this
measurement.
PMEN0597 rev.1 - 06/2023
1
104