Hitachi ADVANCED COLOR PC-ARFH2E Manuel D'installation Et D'utilisation page 112

◆ List of available outputs:
• Deactivated
• SWP 3WV: (Fixed in output 1 if swimming pool is enabled): Signal control of the 3-way valve of
the swimming pool.
• Water pump 3: (Fixed in output 2 if hydraulic separator or buffer tank is installed): Signal control
of the water pump for hydraulic separator or buffer tank.
• Boiler: (Fixed in output 3 if boiler is enabled): Signal control of the boiler.
• Solar Pump: (Fixed in output 4 if solar pump is enabled): Signal control of the solar pump.
• Alarm: (By default in output 5):Signal is active if there is an alarm.
• Operation: (By default in output 6): Signal active in case Thermo-ON in any condition.
• Cooling: (By default in output 7): Signal active when space cooling is operating.
• Dem-ON C1: (By default in output 8): Signal active when there is Demand in circuit 1.
• Heating: Signal active when space heating is operating.
• DHW: Signal active when DHW is operating.
• Solar overheat: Signal is active when solar overheat (only when solar combination status is total
control)
• Defrost: Signal active when outdoor unit is defrosting.
• DHW Re-circulation: Signal active depending on option selected at chapter Circuit pump.
• Fan 1 Low: Signal is active when fan coil speed selected for Circuit 1 is set to Low.
• Fan 1 Medium: Signal is active when fan coil speed selected for Circuit 1 is set to Medium.
• Fan 1 High: Signal is active when fan coil speed selected for Circuit 1 is set to High.
• Fan 2 Low: Signal is active when fan coil speed selected for Circuit 2 is set to Low
• Fan 2 Medium: Signal is active when fan coil speed selected for Circuit 2 is set to Medium.
• Fan 2 High: Signal is active when fan coil speed selected for Circuit 2 is set to High.
• Constant Heating: Signal is active in case operation mode of LCD controller is set to Heating.
• Constant Cooling: Signal is active in case operation mode of LCD controller is set to Cooling.
PMEN0597 rev.1 - 06/2023
1
103