Publicité
5.12 Gearbox Reset
After the gearbox is disassembled or repaired, it will cause shift delay or shock
problems. At this time, this function needs to be executed to make the gearbox
automatically compensate according to the driving conditions in order to achieve a more
comfortable and more ideal shift quality.
5.13 Air conditioning service
After the refrigerant, blower pump, etc. in the air conditioner are replaced, the air
conditioning system may not work normally. At this time, this function is needed to
activate the air conditioner for a period of time to match the replaced refrigerant, blower
pump and other automotive components.
5.14 Air Filter
The engine is a very precise machine part, and even the smallest impurities will
cause the wear of the engine. Therefore, the air must be filtered by the air cleaner before
entering the cylinder. Therefore, the disassembly, maintenance or replacement of the air
filter will cause some particulate impurities in the air to enter the car parts. At this time, the
air filter learning and matching functions need to be performed to make the air filter work
normally.
5.15 Fuel Pump
After the fuel pump is disassembled, repaired or replaced, it may cause the fuel
pump to be unable to continuously provide fuel to the fuel injection nozzle. At this time,
the function needs to be executed to activate the replaced fuel pump so that the car can
start to inject fuel normally and make the engine achieve the ideal Running status.
5.16 Engine Idle
This correction can be executed when the idle speed fault is resolved. Adjust the
engine speed of the car at idle speed.
5.17 Body stability
Learning and calibration after replacing the body stability control unit and other
related components, such as: lateral acceleration sensor for active roll stabilization
system, BAS brake assist system, ESP electronic stability program, calibration of yaw
rate / lateral and longitudinal acceleration sensors, pedal angle Sensors, etc.
5.18 Door
After repairing or replacing the window lift motor, it is necessary to perform relevant
functions for calibration.
Door Window Calibration:
This routine learns the top position of the door window glass, which enables
pinch protection and one touch up function. The door window glass position can be
learned by executing this routine.
5.19 Seat
After repairing or replacing the seat position drive motor, it is necessary to perform
relevant functions for calibration.
Driver's Seat Calibration:
The routine will restore all the seat axis position values to default for the
driver's seat module.
Passenger's Seat Calibration:
The routine will restore all the seat axis position values to default for the
passenger seat module.
22
Publicité
