Publicité
Through the window regulator action test item, you can control the whole vehicle
window up and down to test whether the window up and down works normally.
Windshield wiper motor (V) stage 1 / 2
Through the action test item of windshield wiper motor, the wiper can be controlled
to work at 1 / 2 gear to test whether the wiper motor works normally
4.4 Generic OBDII Operations
A fast-access option for OBDII/EOBD vehicle diagnosis is available on the Vehicle
Menu screen. This option presents a quick way to check for DTCs, isolate the cause of an
illuminated malfunction indicator lamp (MIL), check monitor status prior to emissions
certification testing, verify repairs, and perform a number of other services that are
emissions-related.
4.4.1 General Procedure
To access the OBDII/EOBD diagnostics functions
1.
Tap the Diagnostics application button from the CR Eagle Job Menu. The Vehicle
Menu displays.
2.
Tap the OBD button. The device will automatically establish communication with the
vehicle. When the communication is complete, vehicle protocol information will be
displayed. Tap OK to proceed to the next step.
3.
Select a specific protocol under the Protocol option. Wait for the OBDII Diagnostic
Menu to display.
NOTE
Some functions are supported only on certain vehicle manufacturers.
4.4.2 Function
OBDII has the following function modes:
Read Codes
Erase Codes
I/M Readiness
Live Data
Freeze Frame
Vehicle Information
O2 Monitor Test
On-Board Monitor
Evap System
4.5 Exiting Diagnostics
The Diagnostics application remains open as long as there is active communication
with the vehicle. You must exit the diagnostics operation to stop all communications with
the vehicle before closing the Diagnostics application.
NOTE
Damage to the vehicle electronic control module (ECM) may occur if communication is
disrupted. Make sure all connections, such as diagnostic cable, USB cable and wireless
connections, are properly connected at all times during testing. Exit all tests before
disconnecting the test connection or powering down the tool.
To exit the Diagnostics application
17
Publicité
