Publicité
Les langues disponibles
Les langues disponibles
3. Switch lock: Put the direction of rotation switch in
the centre position.
9.9
Adjusting the torque
ATTENTION
The torque adjusting ring may only be actuated when
idle.
Note:
A clear ratcheting sound is heard when reaching the
preset torque limit. This noise is caused by the slip
clutch.
Note:
You can preset the maximum torque by turning the
torque adjusting ring (3). There are 25 torque levels + 1
drill level.
1. Select the desired torque by turning the torque ad-
justing ring (3).
2. Start with a lower torque level and increase it as re-
quired.
Level 1
Level
Screws
Drilling
9.10
On/Off switch (9) (Fig. 1)
The speed can be steplessly controlled by the on/off
switch. The further you press the on/off switch, the
higher the speed.
1. To switch on the product, push the on/off switch (9).
2. To switch off, release the on/off switch (9).
If you put the direction of rotation switch (10) in the
centre position, the product is secured from being
switched on.
9.10.1
LED work lamp (8)
This product is equipped with an LED work lamp to illu-
minate the immediate work area and improve visibility
in poorly lit environments.
CAUTION
Do not look directly into the LED work lamp or the
light source.
1. The LED work lamp (8) lights up automatically as
soon as the product is switched on.
Note:
The LED work lamp remains lit up for approx. 10 sec-
onds after the product is switched off.
Lowest torque
Highest torque
Level 1 - 25
Level
www.scheppach.com
10 Accessory set
10.1
Cutter knife (24)
1. Press the unlocking on the cutter knife (24) to pull
out the insert with the spare blades.
10.2
Measuring tape (21)
1. Push the locking slider forward to fix the pulled out
measuring tape (21).
2. Release the fixation by pulling back the locking slid-
er.
3. Press and hold one of the locking buttons to tempo-
rarily fix the pulled-out measuring tape (21).
4. With the clip, on the back, you can attach the mea-
suring tape (21) to the belt.
10.3
Center punch (23)
1. With the centre punch (23) you can give a drill an
initial guide at a fixed position to prevent the drill
from running when starting to drill.
2. You can also use the centre punch (23) to mark
workpieces.
3. Place the centre punch (23) with the tip at the de-
sired position and hit the back of the centre punch
(23) with a hammer (not included).
11 Working instructions
* = not included in the scope of delivery!
Torque
• Smaller screws*/bits may be damaged if you set too
high a torque or speed.
Hard screwing case (into metal)
• Particularly high torques occur, for example, with
metal screw connections using sockets. Select a
low speed.
Soft screwing case (e.g. into wood)
• Also screw here with a low speed to ensure the
wood surface is not damaged by contact with the
screw head. Use a countersink.
When drilling into wood, metal and other materials
• Use a high speed for small drill diameters and a low
speed for large drill diameters.
• Select a low speed for hard materials and a high
speed for soft materials.
• Secure or fasten (if possible) the workpiece is a
clamping device*.
• Mark the place where you want to drill with a centre
punch or a nail*. Select a low speed to drill.
• Pull the rotating drill out of the drillhole several
times to remove chips and drilling dust.
GB | 29
Publicité
