Publicité
8
Before commissioning
8.1
Wall mounting of the charger (13)
(Fig. 1)
WARNING
–
Before wall mounting, make sure that there are no
lines in the wall in the area of the drill holes that
could be damaged.
–
Lay the mains cable so that it does not obstruct
you and no one can accidentally pull on it.
–
Children must not play with the product, even if it
is hanging on the wall.
–
Mounting behind doors and their swinging range
is not recommended, as there is a risk of tearing
off or otherwise damaging the product.
WARNING
The product must never be operated on a combusti-
ble surface.
WARNING
Never attach the product to a wet surface.
WARNING
Ensure adequate ventilation.
* = not included in the scope of delivery!
The battery charger has two holes on its back for wall
mounting with two screws*. It can be hung on a wall,
taking into account the safety instructions and the di-
mensions given (see Fig. 1).
8.2
Mounting the belt clip (11)
1. During work breaks, the product can be hooked on-
to the belt with the integrated belt clip (11).
2. Screw the belt clip (11) with the screw (12) to the
right or left screw-on point on the product, as re-
quired. Use a Phillips screwdriver for this (not in-
cluded in the scope of delivery).
Note:
Make sure that the product is switched off and secured
against being switched on.
9
Operation
The cordless drill with 2-gear transmission has a 25+1
level torque adjustment, clockwise/anticlockwise rota-
tion, quick-release chuck and an LED work lamp.
Please refer to the following descriptions for the func-
tion of the controls.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
9.1
Inserting/removing the battery (5)
in the battery mount (6) (Fig. 2)
Inserting the battery
1. Put the rotational direction switch (10) in the middle
position (lock).
2. Push the battery (5) into the battery mount (6). The
battery (5) clicks into place audibly.
Removing the battery
1. Press the unlock button (7) of the battery (5) and re-
move it from the battery mount (6).
9.2
Check the charge status of the
battery
The charge status indicator (28) indicates the charge
status of the battery (5).
The charge status of the battery is indicated by the cor-
responding LED light lighting up.
1. Press the charge status indicator button on the bat-
tery (27).
LED on the battery
red-orange-green
red-orange
red
9.3
Depleted batteries
• A significantly shortened operating time despite
charging indicates that the battery has been used
up and needs to be replaced. Only use original re-
placement batteries.
• In any case, observe the applicable safety instruc-
tions as well as regulations and instructions on envi-
ronmental protection (see "Disposal and recycling").
www.scheppach.com
Charging status
Battery full
Battery partially charged
Battery empty
GB | 27
Publicité
