Publicité
TROUBLESHOOTING
Symptom
POOR SOUND QUALITY
Unstable or interrupted
sound.
No high frequencies.
High frequencies are
emphasized.
Sound from previous
recordings remains when
rerecording a tape.
The sound is distorted.
Too much noise
OTHERS
The music search function
does not work.
Cannot use the remote
control system. (Except for
CT-W803RS)
CDeDECK SYNCHRO is
disabled.
The CD SYNC indicator is
off during CDeDECK
SYNCHRO recording.
Cause
¢
The head, pinch roliers and capstans are dirty.
e
The tape is not uniformly wound.
¢
A tape recorded without Dolby NR is being
played back with DOLBY NR switch in the B , C
or S position.
e
The head is dirty.
e
A Dolby NR-encoded tape is being played back
with DOLBY NR ON/OFF switch in the OFF
position.
¢
The head is dirty.
e
Recording level is too high.
¢
The recorded signal itself is distorted.
@
The head is dirty.
¢
High noise tape is being used.
¢
Incomplete insertion of a connection cord, poor
contact.
©
Recording level is too low.
®
The head is dirty.
®
The head is magnetized.
¢
Blanks between selections are less than 4
seconds long.
e
The control cord is not connected.
©
The components are not connected properly.
®
The cassette erasure prevention tabs are broken.
®
The tape ran out during the CDeDECK SYNCHRO
mode.
e
After the deck entered recording standby mode,
more than 1 minute elapsed before the CD player
resumed playback.
Remedy
e
Clean (see page 8).
e
Completely fast-forward or rewind the tape.
e
Set DOLBY NR ON/OFF switch to OFF.
©
Clean the head (see page 8).
e
Set the DOLBY NR ON/OFF switch of ON first,
then set the DOLBY NR switch to the same posi-
tion used for recording.
®
Clean the head (see page 8).
@
Turn REC LEVEL contro! down when recording
(see page 38).
©
Replace the cassette.
e
Clean the head (see page 8).
e
Replace the cassette.
®
Check connections (see page 10).
©
Turn REC LEVEL control up when recording (see
page 38).
e
Clean the head (see page 8).
@
Demagnetize with a head demagnetizer.
e
Use a tape with blanks more than 4 seconds
long.
©
Connect the control cord (see page 10).
©
Connect them properly (see page 10).
©
Replace the cassette with one whose tabs are
intact.
e
Replace the tape with a longer one.
e
Change the disc and press the CD SYNC button
again.
ee
ie en
ee
ee
a
ee
el
nie
sn
(RR
EERE
tenement
ey
a
eee
ROR
OT
es
ee nae
Se
Se
a
(SS
pe
OS ee Se
||
55
<RRE1O90>
En
Publicité
