Samson TROVIS 3730-1 Notice De Montage Et De Mise En Service page 138

Certificats
9. This certificate relates to the design, examination and testing of the products specified herein. The FM
Approvals surveillance audit program has further determined that the manufacturing processes and quality
control procedures in place are satisfactory to manufacture the product as examined, tested and Approved.
10. Equipment Ratings:
Intrinsically Safe for Class I, II, III Division 1, Groups A, B, C, D, E, F, and G hazardous (classified)
locations in accordance with drawing EB 8484-1 , Intrinsically Safe for Class I, Zone 1, Group IIC
hazardous (classified) locations in accordance with drawing EB 8484-1; Nonincendive for Class I, II, III
Division 2, Groups A, B, C, D, F, and G hazardous locations, indoors and outdoors (Type 4X, IP66) with an
ambient temperature rating per the table in Section 12 below
11. The marking of the equipment shall include:
IS Class I, II, III, Division 1, Groups A, B, C, D, E, F, G; T* Ta*
Ex ia IIC T* Gb
NI Class I, II, III Division 2, Groups A, B, C, D, F, G; T* Ta*
Type 4X; IP66
For Entity and NIFW parameters – refer to document no. EB8484-1
T* - See below
Description of Equipment:
12.
General – The TROVIS 3730-1 Positioner is a single acting positioner for attachment to pneumatic
control valves. The positioner mainly consists of a non-contact travel sensor system, an i/p converter
and the electronics with the microcontroller. The valve position is transmitted either as an angle of
rotation or a travel to the pick-up lever, from there to the travel sensor and forwarded to the
microcontroller. The PID algorithm in the microcontroller compares the valve position measured by the
travel sensor to the 4 to 20 mA DC control signal issued by the control system after it has been
converted by the AD converter. In case of a set point deviation, the i/p converter causes the actuator to
be either vented or filled with air. As a result, the closure member of the valve is moved to the position
determined by the reference variable. The pneumatic module is supplied with supply air and the flow
rate of the module's output can be restricted by software
Construction - The Type TROVIS 3730-1 Positioner mainly consists of the electronics part. The parts
are assembled in an enclosure made of aluminium die cast or stainless-steel die cast. The enclosure
has a cover with a polymeric inspection window. As an alternative to the polymeric material, the window
can be made from aluminium. The enclosure has an ingress protection rating of Type 4X and IP66
THIS CERTIFICATE MAY ONLY BE REPRODUCED IN ITS ENTIRETY AND WITHOUT CHANGE
FM Approvals LLC. 1151 Boston-Providence Turnpike, Norwood, MA 02062 USA
T: +1 (1) 781 762 4300 F: +1 (1) 781 762 9375 E-mail:
F 348 (Apr 21)
15-22
SCHEDULE
Canadian Certificate Of Conformity No: FM21CA0063
information@fmapprovals.com www.fmapprovals.com
Page 2 of 4
EB 8484-1 FR