Publicité
GB
IE
IT
CH
the count of the three consecutive cases.
ATTENTION: reaching the delta degrees in the positive reading resets the count of the three consecutive cases.
WARNING: the MAX value set, where present, corresponds to a fictitious value of 90 °C
-it works by deactivating and preventing all settings except: LANGUAGE + OFF, the error triangle flashes and an
intermittent beep sound.
-THE FIRST ACTION IS TO TAP ON ANY POINT ON THE SCREEN, which will deactivate the beep sound and the
flashing of the error triangle
-the message resets by RESTARTING the ON/OFF CONTROLLER
Lack of heating, turn off and see manual
"er05"
ALL FUNCTIONS ARE SWITCHED OFF
-Active on the following products: WITH INDUCTION TECHNOLOGY
-message warning of an error in the induction circuit
-it occurs when an error is communicated via the RS485 protocol from the inductive BRIDGE to the base board or when
there is no communication between the base board and the BRIDGE; in both cases, the error must be present and constant
for at least 3 seconds.
-it works by deactivating and preventing all settings except: LANGUAGE + OFF, the error triangle flashes and an
intermittent beep sound.
-THE FIRST ACTION IS TO TAP ON ANY POINT ON THE SCREEN, which will deactivate the beep sound and the
flashing of the error triangle
-THE MESSAGE IS RESET BY RESTARTING THE OFF/ON CONTROLLER
WARNING: if there is no communication, the displayed error will be "E0.00"; if there is communication and the BRIDGE
shows an error, the code in the text string will change accordingly:
(E1.1 / E1.2 / E1.3 .........E2.1 / E2.2 / E2.3 ......... E3.1 / E3.2 / E3.3 ......... E4.1 / E4.2 ...)
Induction error "E...", turn off and see manual
82
Publicité
