Pattfield Ergo Tools PE-EAS 7520 Mode D'emploi page 327

12. Troubleshooting
Caution!
Before troubleshooting, switch off the tool and disconnect the mains
plug.
The table below contains a list of fault symptoms and explains what
you can do to remedy the problem if your tool fails to work properly.
If the problem still persists after working through the list then please
contact your nearest service workshop.
Cause
Chainsaw
does not
work at all
Chainsaw
operates in-
termittently
Saw chain
dry
Anl_PE_EAS_7520_SPK7.indb 327 Anl_PE_EAS_7520_SPK7.indb 327
Fault
- No power supply
- Defective mains outlet
- Power extension cable
damaged
- Defective fuse
- Loose connection (ex-
ternal)
- Loose connection (in-
ternal)
- ON/OFF switch defecti-
ve
- No oil in the tank
- Oil tank cap breather
blocked
- Oil outlet blocked
- 327 -
Remedy
- Check the power sup-
ply.
- Try an alternative sour-
ce of electrical power,
replace if necessary.
- Check the cable and
replace as required.
- Replace the fuse.
- Consult a specialist
workshop.
- Consult a specialist
workshop.
- Consult a specialist
workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
GB
14.06.2022 09:43:28 14.06.2022 09:43:28