Publicité
test there. It is therefore safest to position the saw as fl at as possible.
Warning!
•
Make sure that the chain tension is always correctly adjusted.
•
Only use a chainsaw if it is in perfect working order.
•
Only work with a saw chain that has been properly sharpened in
accordance with the instructions.
•
Never cut with the upper edge or the tip of the cutter rail.
•
Always hold the chainsaw firmly with both hands.
Cutting wood which is under tension
Danger!
Special care is required when cutting wood which is under tension.
Wood which is under tension from which it is released by cutting may
in some cases react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or even fatal inju-
ries. This type of work must only be performed by persons who have
been specially trained.
8. Maintenance
Keep the machine, the cutter set and the cutter set guard in good
working condition.
There are no parts inside the equipment which require additional
maintenance.
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
the guide groove of the cutter rail is worn;
Proceed as described in the section "Assembly of the cutter rail and
the saw chain".
Use only saw chains and cutter rails approved by the manufacturer.
These are listed in section 4 "Technical data" or are available as ac-
cessories (see section 10.3 "Ordering spare parts"). The use of spare
parts which are not approved by the manufacturer could result in very
Anl_PE_EAS_7520_SPK7.indb 323
Anl_PE_EAS_7520_SPK7.indb 323
- 323 -
GB
14.06.2022 09:43:27
14.06.2022 09:43:27
Publicité
