Publicité
serious injuries.
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic chain lubrication
system on a regular basis in order to guard against overheating and
the associated damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth surface (board,
section of a cut tree) and allow the chainsaw to run. If an increasing
oil trace becomes evident during this process then the automatic
chain lubrication system is working properly. If no clear oil trace is
evident then please refer to the corresponding instructions in "Troub-
leshooting". If the information contained there still fails to remedy the
situation then please contact our service department or another simi-
larly qualifi ed workshop. Important! Do not actually touch the surface
with the tip of the cutter rail when performing this test. Keep a safe
distance (approx. 20 cm).
8.3 Sharpening the saw chain
Eff ective working with the chainsaw is only possible if the saw chain
is in good condition and sharp. This also reduces the risk of kickback.
GB
The saw chain can be re-sharpened by any dealer. Do not attempt to
sharpen the saw chain yourself unless you have the necessary spe-
cial tools and experience.
9. Replacing the power cable
Danger!
If the power cable for this equipment is damaged, it must be replaced
by the manufacturer or its after-sales service or similarly trained per-
sonnel to avoid danger.
Anl_PE_EAS_7520_SPK7.indb 324
Anl_PE_EAS_7520_SPK7.indb 324
- 324 -
14.06.2022 09:43:27
14.06.2022 09:43:27
Publicité
