Publicité
Danger! The protective devices must not be removed or modifi ed.
- Danger of accident! Never use the saw if the safety equipment
is not working properly. Never try to repair safety related protection
systems yourself – always have any work done by our service depart-
ment or by a similarly qualifi ed workshop.
Use only the accessories and spare parts approved by the manufac-
turer, otherwise there is a risk of accidents or damage to the equip-
ment.
Oil container
Fill level of the oil container. Even while working, keep checking that
suffi cient oil is in the system. To avoid damaging the chainsaw, never
run the saw if there is no oil in the system or if the oil drops below the
"min" mark. On average, a single fi lling will last around 10 minutes de-
pending on the number of pauses in cutting and the loads involved.
Saw chain
Tension of the saw chain, condition of the cutting elements. The shar-
per the chainsaw, the easier and more controllable it is to operate
the chainsaw. The same also applies to the chain tension. Also while
GB
working you should check the chain tension no less than every 10
minutes in order to increase your safety. New saw chains in particular
often tend to expand more.
Do not touch the saw chain while the device is switched on. If the saw
chain is blocked by an object, switch the device off at once – then re-
move the object – Danger of injury!
Safety clothing
Always wear appropriate tight-fi tting safety clothing like special
trousers which protect against cuts, protective gloves and safety
shoes.
Anl_PE_EAS_7520_SPK7.indb 320
Anl_PE_EAS_7520_SPK7.indb 320
- 320 -
14.06.2022 09:43:27
14.06.2022 09:43:27
Publicité
