Attaching/removing the nozzles
If you would like to use one of the other enclosed nozzles, it must fi rst be attached to the nozzle
adapter (F):
•
The nozzle adapter will be attached to the main unit in the exact same manner as the cleaning
•
head : Insert the nozzle adapter in the steam nozzle (9) of the main unit until the catch au-
dibly locks into place.
•
To remove the nozzle adapter, depress the catch and pull the adapter out at the same time.
Attaching the fl oor pad and carpet cleaning head
Filling the water tank
ATTENTION!
❐ Always turn off the appliance before you fi ll the water tank.
❐ Never fi ll the appliance with cleaners or other additives. They may irreparably damage the
appliance and as such, the safe operation of the appliance can no longer be assured.
If the power LEDs (12) are blinking red, the water tank (7) is empty and has to be fi lled.
We recommend that, ideally, you fi ll the water tank with distilled water to prevent
calcifi cation, especially if the hardness of your tap water is very high.
5. Take the water tank out of the appliance to fi ll it. To do so, depress both side release but-
tons (6).
6. Open the water tank: Turn the water tank lid (5) a bit in a counterclockwise direction and
remove it.
•
An arrow is embossed on the end piece of the nozzle and the
nozzle adapter. Connect the two parts so that the arrows are
pointing towards one another and then turn the nozzle to the
stop.
•
To remove the nozzle, turn it back until the arrows on the nozzle
and adapter are pointing towards one another and pull it out.
•
The fl oor pad (K) is attached to the cleaning head with Velcro
straps. Place it on the cleaning head and push it fi rmly. After use,
simply pull it off of the cleaning head.
•
To clean carpets, place the carpet cleaning head (M) fl at on the
fl oor and place the cleaning head with the fl oor pad in the carpet
cleaning head. Press cleaning head fi rmly into the carpet cleaning
head until it locks into place.
23