Miele PWM 509 Mode D'emploi page 133

Masks programmes
Masks are programmes for washing and disinfecting breathing masks with head straps.
Put the head bands over the masks to protect the visors before loading the machine.

Put each mask into its own protective bag and fasten it.

The protective bags are available to order from the Miele Customer Service Department.
Remove the masks from the bags after reprocessing.

Spin damp, empty protective bags using the Spin bags programme.

Masks
Load
Programme se-
quence
Extras
Masks with pre-wash
Load
Programme se-
quence
Extras
Spin wash bags
Load
Programme se-
quence
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time and dispensing
quantities) must be set on site to suit detergents and disinfectants.
If "Pre-wash" is selected, place the detergent directly in the drum. If necessary, the 
and  compartments can be used to add detergent in the main wash cycle.
To avoid recontamination, the water inlet for the rinse cycles in the disinfection pro-
grammes is not supplied via the detergent drawer.
Do not wash masks with connections for helmet-mask combinations.
The clasps are likely to scratch visors.
Use a suitable detergent. Observe the manufacturer's instructions.
60 °C
Breathing masks with head straps
Disinfection* 60 °C, holding time 20 min
4 rinse cycles (optional disinfection rinse can be activ-
ated), drainage
Soak, Intensive, Rinse plus, Fill stop, Rinse hold
60 °C
For heavily soiled breathing masks with head straps
Pre-cleaning 30 °C
Disinfection* 60 °C, holding time 20 min
4 rinse cycles (optional disinfection rinse can be activ-
ated), drainage
Soak, Intensive, Rinse plus, Fill stop, Rinse hold
Mask bags
Spinning
en - Programme summary
Load ratio/load size
PWM 509 –
4–5 masks
PWM 511 –
6–7 masks
1:20
133