Miele PWM 509 Mode D'emploi page 130

en - Programme summary
Cloths rtu
Fabric
Programme se-
quence
Extras
Cloths load size applies to the load ratio 1:18
Cloths size/weight
PWM 509
PWM 511
The programme Standard cloths is also suitable for cleaning cloths that are not to be
used immediately after washing, but are to be stored after drying.
With the Cloths . . . + rtu programmes, the cloths are ready to use and already impreg-
nated with detergent and disinfectant. To achieve this, following washing or disinfection
there is a finishing stage and then a final spin. The desired moisture level of the cloths can
vary by setting the residual moisture via the extra " – " (moist, damp, wet, dripping
wet). Dispensing quantities must be set on site and the standard of disinfection must be
checked.
The Cloths rtu programme is suitable for the subsequent finishing of clean and dry clean-
ing cloths. A disinfecting agent is applied during finishing. Dispensing quantities must be
set on site and the standard of disinfection must be checked.
130
Cotton, viscose, polyester and microfibre cleaning
cloths
1 rinse cycle
then set the residual moisture via the extra " – "
(moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Fill stop, Rinse hold
16 g/cloth
290
350
22 g/cloth
210
255
Load ratio/load size
1:18
PWM 509 – 4.6 kg
PWM 511 – 5.6 kg
For number,
see
"Cloths load size"
chart
43 g/cloth
105
130