Miele PWM 509 Mode D'emploi page 124

en - Programme summary
Mops ch-th dis 20min+rtu
Fabric
Programme se-
quence
Extras
Mops rtu
Fabric
Programme se-
quence
Extras
New mops
Fabric
Programme se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time and dispensing
quantities) must be set on site to suit detergents and disinfectants.
If "Pre-wash" is selected, place the detergent directly in the drum. If necessary, the 
and  compartments can be used to add detergent in the main wash cycle.
The Mops rtu programme is suitable for the subsequent finishing of clean and dry mops. A
disinfecting agent is applied during finishing.
Dispensing quantities must be set on site and the standard of disinfection must be
checked.
Mop load size (cotton) applies to the load ratio 1:9
Mop size/ 40 cm
weight 190 g/
mop
PWM 509
PWM 511
Tip: When using microfibre mops, the load size is higher due to the lower mop weight.
124
60 °C
Cotton, viscose, polyester and microfibre mops
Programme sequence as for Mops chemo-thermal
disinfection*,
then set the residual moisture via the extra " – "
(moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop, Rinse
hold
Cotton, viscose, polyester and microfibre mops
1 rinse cycle
then set the residual moisture via the extra " – "
(moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Fill stop, Rinse hold
60 °C (Cold to 90 °C)
For washing new mops
Main wash up to 90 °C, wash time 4 min
Cool down can be activated in the Miele Benchmark
Programming Tool
2 rinse cycles
Final spin
Soak, Water plus, Intensive, Rinse plus, Fill stop, Rinse
hold
50 cm
220 g/
mop
47 41
58 50
60 cm 80 cm
280 g/ 360 g/
mop mop
32 25
39 31
Load ratio/load size
1:10
PWM 509 – 8 kg
PWM 511 – 10 kg
PWM 509 – 9 kg
PWM 511 – 11 kg
For number,
"Mops load size"
chart
110 cm 130 cm
510 g/ 610 g/
mop mop
18 15
22 18
1:9
see
160 cm
720 g/
mop
13
15