Miele PWM 509 Mode D'emploi page 123

Mops ch-th disinf 10 min
Fabric
Programme se-
quence
Extras
Mops ch-th disinf 20 min
Fabric
Programme se-
quence
Extras
Mops ch-th dis 10 min+rtu
Fabric
Programme se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time and dispensing
quantities) must be set on site to suit detergents and disinfectants.
If "Pre-wash" is selected, place the detergent directly in the drum. If necessary, the 
and  compartments can be used to add detergent in the main wash cycle.
70 °C
Cotton, viscose, polyester and microfibre mops
Pre-spin
Pre-rinse bath
2nd pre-rinse bath can be activated via extra  "Pre-
rinse"
Disinfection* 70 °C, holding time 10 min
3 rinse cycles (optional disinfection rinse can be activ-
ated)
Final spin
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop, Rinse
hold
60 °C
Cotton, viscose, polyester and microfibre mops
Pre-spin
Pre-rinse bath
2nd pre-rinse bath can be activated via extra  "Pre-
rinse"
Disinfection* 60 °C, holding time 20 min
3 rinse cycles (optional disinfection rinse can be activ-
ated)
Final spin
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop, Rinse
hold
70 °C
Cotton, viscose, polyester and microfibre mops
Programme sequence as for Mops chemo-thermal
disinfection*,
then set the residual moisture via the extra " – "
(moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop, Rinse
hold
en - Programme summary
Load ratio/load size
PWM 509 – 8 kg
PWM 511 – 10 kg
1:10
123