Miele PWM 509 Mode D'emploi page 122

en - Programme summary
Mops thermal disinfection
Fabric
Programme se-
quence
Extras
Mops thermal disinf + rtu
Fabric
Programme se-
quence
Extras
If "Pre-wash" is selected, place the detergent directly in the drum. If necessary, the 
and  compartments can be used to add detergent in the main wash cycle.
122
90 °C
Cotton, viscose, polyester and microfibre mops
Pre-spin
Pre-rinse bath
2nd pre-rinse bath can be activated via extra  "Pre-
rinse"
Disinfection 90 °C, holding time 10 min
Cool down and/or disinfection rinse can be activated
in the Miele Benchmark Programming Tool
3 rinse cycles
Final spin
Pre-rinse, Soak, Water plus, Intensive, Rinse plus, Fill
stop, Rinse hold
90 °C
Cotton, viscose, polyester and microfibre mops
Same programme sequence as Mops thermal disin-
fection,
then set the residual moisture via the extra " – "
(moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Water plus, Intensive, Rinse plus, Fill
stop, Rinse hold
Load ratio/load size
1:9
PWM 509 – 9 kg
PWM 511 – 11 kg
For number,
see
"Mops load size"
chart