Publicité
E N G L I S H
F. ANTI-TIP TUBES- REAR
Anti-tip tubes are recommended for all wheelchairs.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up anti-tip tubes.
1. Inserting Anti-Tip Tubes Into Receivers
a. Press the rear anti-tip release pin (A) on the anti-tip tube so that both release pins are
drawn inside of tube.
b. Insert the anti-tip tube into the receiver (B).
c. Turn the anti-tip tube down until front release pin protrudes through the rear receiver
mounting hole.
d. Insert second anti-tip tube the same way.
2. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing
curbs.
a. Press the rear anti-tip tube release pin (A).
b. Hold pin in and turn anti-tip tube up (C).
c. Release pin.
d. Repeat with second anti-tip tube.
e. Remember to return anti-tip tubes to down position after completing maneuver.
3. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be raised or lowered to achieve proper ground clear-
ance (1-1/2" to 2").
a. Press the anti-tip wheel release pin (D) so that the release pin is drawn inside.
b. Raise or lower to one of the pre-drilled holes.
c. Release pin (D).
d. Adjust the second anti-tip tube wheel the same way. Both wheels should be at exactly
the same height.
G. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed by Sunrise Medical. The tilt mechanism positively
locks the chair in place from 0º to 45º.
1. Trigger Tilt Operation
a. Depressing both triggers (C) at the same time disengages the locking mechanism and
allows the seat and back to rotate in space. Releasing the triggers positively locks the
rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (D).
c. To lock out the tilting function, insert the locking pin (E) into the trigger holder.
10
11
2. Foot Release
a. Depressing foot pedal (F) disengages the locking mechanism and allows the seat and
back to rotate in space. Releasing the foot pedal positively locks the rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (D).
3. Tilt-stops Adjustment
Adjustments can be made to limit the amount of tilt (rotation) that the chair provides by
using the tilt-stops (G).
a. Loosen and remove the retaining screw (H).
b. Locate the tilt-stops to the desired limit either anterior or posterior.
c. Each half of tilt stop assembly should plug into directly opposing holes on the rocker
(I), then secure in place by tightening the screw (H).
7
8
7
7
8
9
10
12
15
IX. SET-UP & DJUSTMENT
7
A B
C
8
D
9
E
C
10
D
11
F
I
12
G
H
118611 Rev. B
Publicité
