Publicité
Les langues disponibles
Les langues disponibles
It is not permitted to attach additional holders
u
to the fork, e.g. for panniers, in conjunction with
an ABS.
Before each trip
Check to ensure that the ABS indicator light is work-
ing correctly on the display and/or operating unit
whenever you switch the eBike on. You can find more
information about this in the section entitled (see
"ABS indicator light", page English – 11).
Please check the condition and roadworthiness of the
eBike before every journey. It is the eBike rider's re-
sponsibility to check the eBike is in perfect working
order and fully roadworthy before every journey. Us-
ing the eBike with known faults increases the risk of
injury to the rider.
Always check that the front and rear brakes are work-
ing properly before each trip.
Check to ensure that the thickness of the brake pads
and the brake discs meets the manufacturer's specifi-
cations before setting off.
Check the ABS control unit is fitted securely to the
fork.
Before your first trip
Familiarize yourself with how the brakes and ABS
work and how they respond when you actuate them,
for example by practicing your braking technique
away from busy roads.
The braking power can change over time and a run-
ning-in period may be necessary when the brakes are
new or when the brake pads have been replaced. For
more information about the braking system, refer to
the brake manufacturer's instruction manual.
During the trip
Adapt your riding style to the present riding situation,
the road conditions and your cycling abilities.
Please be aware that the ABS may increase your brak-
ing distance.
On slippery surfaces, the tires skid more easily and
there is a increased risk of a fall. You should therefore
Bosch eBike Systems
Operation
reduce your speed, applying the brakes in good time
using a steady pressure.
ABS indicator light
The ABS indicator light must come on after starting
the eBike and must go out again once you start riding
at a speed of approx. 3 mph.
If the indicator light does not go out once you have
started riding or comes on while riding, this means
that there is a fault with the ABS or there is a shut-
down of the ABS functionality indicated by the user. If
a display or on-board computer is connected, you will
also be shown an error code on this. You can also
view a saved error code on the eBike Flow app. The
ABS will then be disabled. The brake system will con-
tinue working, simply without the control provided by
the ABS.
Always have repairs carried out by a profes-
u
sional.
The functionality of the rear-wheel brake is not af-
fected by whether or not the ABS is working.
WARNING – ABS indicator light on.
u
If the ABS indicator light is on, the ABS function is
no longer active.
Note: The ABS indicator light may come on in ex-
treme riding situations where the front wheel and the
rear wheel are turning at very different speeds, for ex-
ample when riding solely on the rear wheel or if a
wheel is turning for an unusually long period without
making contact with the ground (assembly stands).
This will switch the ABS off. To re-enable the ABS,
stop the eBike and restart it (switch it off and on
again).
CAUTION – Faults with the ABS cannot be sig-
u
naled if the ABS indicator lamp is defective.
When starting the eBike, the rider must therefore
check to ensure that the ABS indicator light is lit;
otherwise the eBike will indicate a critical error by
flashing red on the operating unit. Contact a dealer
if this happens.
English – 11
0 275 U08 3AS | (07.03.2024)
Publicité
