Phone Calls With Base (Bs); Calling; Accepting A Call; Phone Call With A Connected Headset - HumanTechnik Scalla3 combo Mode D'emploi

Masquer les pouces Voir aussi pour Scalla3 combo:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 86

Phone calls with Base (BS)

Calling

1. Lift the telephone receiver or press the
key
.
2. Enter the phone number.
3. To end the phone call, hang the phone
receiver up or press the key again

Accepting a call

1. The phone rings.
2. Lift the telephone receiver or press the
key
.
3. To end the phone call, place the phone re-
ceiver back or press the key again

Phone call with a connected headset

- Calling
1. Press the key
2. Enter the phone number.
3. To end the phone call press the key again
.
- Accept a call
1. The phone rings.
2. Press the key
through the connected headset.
3. To end the phone call press the key again
Use of the equipment loudspeaker du-
ring a call
1. Press and hold the key to switch the
equipment loudspeaker on
loudspeaker of the receiver continues to
be switched on.
56 English
.
to pass the call
. The
2. Hang the receiver up to switch the equip-
ment loudspeaker on.
3. You can now continue the phone call
through the equipment loudspeaker and
the installed microphone.
4. Press key to switch the equipment louds-
peaker off
.
Note:
A call will be disconnected if you press the
key
while the receiver has been hung
up.
Adjusting the volume of the equipment
loudspeaker
.
In hands-free mode, you can adjust the rin-
ger volume of the equipment loudspeaker
by using the keys
placed on the left side of the phone.

Redial the last dialed phone number

1. Lift the telephone receiver.
2. By pressing the key
number will be dialed.
Adjusting the receiver volume/high/low
frequencies
The receiver volume can be adjusted during
a phone call by using the »Volume« slide
switch on the front of the phone (see figure
1, page 57).
An additional amplification can be switched
on by using the
40 dB is achieved if the additional amplifi-
cation is switched on. The status display on
the phone is illuminated if the amplification
has been switched on. The additional amp-
lification will be switched off by pressing the
key again.
.
or
, which are
, the last dialed
/P
key. A volume of up to

Publicité

Table des Matières
loading

Table des Matières