Publicité
Les langues disponibles
Les langues disponibles
Installation
Positioning and connection
Unpacking
1. Carefully remove the protections and the
adhesives, open the door and make sure all the
components are present.
2. Take out the power supply cable.
Positioning
1. Position the device in a well ventilated area,
not damp and free (avoid cabinets with closed
walls).
2. Keep the device away from heat sources.
3. Make sure the minimum distances between
the device and the walls of the room where it
is placed are kept, in order to ensure perfect
ventilation of the device.
See figure.
Ventilation space:
at least 50 mm
Wiring connection
After transport, stand the device vertically, and
wait for at least 3 hours before connecting it to
the wiring system. Before putting the plug into the
power socket, make sure that:
• the socket is earthed and according to legal
• regulations;
• the socket is able to hold up to the maximum
power load of the machine, indicated on the
Data Sheet table or on the feature plate to the
bottom right (see Description of the device);
• the power supply voltage falls within the
range indicated on the Data Sheet table or
on the feature plate to the bottom right (see
Description of the device);
• the power socket is compatible with the plug
of the device. Otherwise, replace the socket
or the plug; do not use extensions or multiple
sockets.
Dimensions
of the
compartment
Here "PUSH TO OPEN"
Here "PUSH TO CLOSE"
23
Dimensions
of the cellar
Furniture
side area
Publicité
