Télécharger Imprimer la page

Whirlpool W WC5120 Mode D'emploi page 20

Publicité

Les langues disponibles

Les langues disponibles

floors (e.g. parquet) when moving
the appliance. Install the appliance
on a floor or support strong
enough to take its weight and in a
place suitable for its size and use.
Make sure the appliance is not
near a heat source and that the
four feet are stable and resting on
the floor, adjusting them as
required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on,
to ensure that the refrigerant
circuit is fully efficient.
To
guarantee
ventilation, leave a space on both
sides and above the appliance.
The distance between the rear of
the appliance and the wall behind
the appliance should be 50mm, to
avoid access to hot surfaces. A
reduction of this space will increase
the
Energy
consumption
product.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or
fixing of the appliance must be
done in accordance with the
manufacturer instructions.
It's forbidden to place the wine
cellar in such way that the metal
hose of gas stove, metal gas or
water pipes, or electrical wires are
in contact with the refrigerator
back wall (condenser coil).
There is not foreseen door
reversibility. Do not try to reverse
the door.
ELECTRICAL WARNINGS
It
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-
pole switch installed upstream of
the socket in accordance with the
wiring rules and the appliance
must be earthed in conformity
with national electrical safety
standards.
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not
be accessible to the user after
installation. Do not use the
adequate
appliance when you are wet or
barefoot.
Do not operate this appliance if it
has a damaged power cable or
plug, if it is not working properly,
or if it has been damaged or
dropped.
If the supply cord is damaged, it
of
must be replaced with an identical
one by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard
- risk of electrical shock.
WARNING:
multiple portable socket-outlets
or portable power supplies at the
rear of the appliance.
20
must
be
possible
Do
not
to
locate

Publicité

loading