Télécharger Imprimer la page

Fysic FW15 Manuel D'utilisation page 26

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
7. Install the axle with pedals (10) to the arched tube (4) with 2 pieces of screws M8x30 (19), 4 pieces
of washers M8xØ16 (20) and 2 pieces of nuts M8 (22). Make sure that the connection of the training
computer is connected to the pedals, see the drawing. Use the wrench (13) and hexagonal wrenches
to tighten the screws. Do not fully tighten the screws yet.
8. Install the axle with handgrips (2) to the upper tube (8) with 2 pieces of screws M8x12 (17), 2 pieces
of washers M8xØ16 (20) and 2 pieces of nuts M8 (22). Use the wrench (13) and hexagonal
wrenches to tighten the screws. Do not fully tighten the screws yet.
7
9. Place the training computer (7) in the stand of the arched tube (4) and connect the cables.
10. Turn the resistance knobs (1 + 11) on the axle with handgrips and axle with pedals.
11. Finally, use the wrench (13) and hexagonal wrenches to tighten all screws.
9
General information
The pedal strap is adjustable according to your foot size. Release the strap and choose the desired
size and reattach the strap to the pedal.
During exercise, rotate the resistance knobs (1+11) on the axle with handgrips or axle with pedals to
adjust the resistance level.
Clockwise rotation = more resistance during cycling.
Counter-clockwise rotation = less resistance during cycling.
How to adjust the height of the bike?
1. Loose the tightening screws (3) on the upper tube (8) of the FW15 Trainer.
2. Pull the bolt (6) out of the lower tube (9) and place it in the desired position to adjust the height of the
FW15 Trainer.
3. Tighten the tightenings screws (3) to the upper tube (8).
8
10
25

Publicité

loading